Proposal for optimization of a pull / push process follow-up of flexible packaging in the extrusion area

Most read articles by the same author(s)

• Jayne Rodrigues de Souza , Fernando dos Reis Aragão , Marcos Raiker Printes Ferreira , Antonio Estanislau Sanches , David Barbosa de Alencar , Jorge Almeida Brito Junior , Analysis of the environmental temperature according to the type of soil surface in the city of Manaus (154-163) , ITEGAM-JETIA: Vol. 4 No. 15 (2018)
• Alexandre de Pina Braga , Adelaneide Gomes de Lima , Murilo Ferreira dos Santos , Thiago Manuel Gonçalves dos Santos , David Barbosa de Alencar , Antonio Estanislau Sanches , traffic in the Gilberto Mestrinho complex road in Manaus city: A case study (152-156) , ITEGAM-JETIA: Vol. 4 No. 16 (2018)
• Fransoermes Torres Lima , Edson Andrade Ferreira , David Barbosa de Alencar , Jorge de Almeida Brito Junior , Carlos Alberto Oliveira de Freitas , Manoel Henrique Reis Nascimento , Gray water reuse system from air conditioners for non-potable purposes: case study applied at the Secretary of State of Finance – SEFAZ headquarters building in the city of Manaus-Am (177-182) , ITEGAM-JETIA: Vol. 4 No. 15 (2018)
• Bianka Caroline Cunha Firmino , Murilo Ferreira dos Santos , Darlei dos anjos Lavor , David Barbosa de Alencar , Larissa de Sá Sousa , Edson Andrade Ferreira , Physical-mechanical performance of the concrete produced with fiber addition jute plant in the partial replacement of Portland cement in 05% and 10% , ITEGAM-JETIA: Vol. 5 No. 17 (2019)
• Charles Castro Ferreira , José Roberto Lira P. Júnior , Luiz Felipe de Araújo Costa , Mauro Cesar Aparício de Souza , David Barbosa de Alenca5 , Antonio Estanislau Sanches , Industry 40: The use of industrial automation with the internet assistance of the things in the control of electricity via local network in the city of Manaus-AM , ITEGAM-JETIA: Vol. 5 No. 17 (2019)
• Bruno Marques dos Santos , Fernando Neves de Almeida , Railey Martins Braga , Luiz Felipe de Araújo Costa , Improvement in the manufacturing process of the motorcycle gear part , ITEGAM-JETIA: Vol. 3 No. 9 (2017)